CWP-M • Air/water heat pumps R290 Monoblock

The CWP-M is a DC inverter controlled monoblock heat pump with R290 refrigerant.

By using the natural refrigerant R290 with a GWP value of only 3, the heat pump uses the heat in the outdoor air in an environmentally friendly and cost-saving way to heat, cool and provide your home with sanitary hot water. The construction of the unit makes it possible to heat water up to 75°C at outdoor temperatures down to -7°C without using a resistance. The unit guarantees proper operation down to -25°C outside temperature. The fully bubble-foam-lined interior, the compartmentalized compressor, the acoustically optimized fan and blades contribute to extremely quiet operation. The exterior of the monoblock is made of ASA plastic, making it resistant to all weather conditions. The contemporary design and anthracite colour are characteristic for this heat pump.

• R-AQUA

• Heating of new or existing houses
• Heating by means of radiators, convectors or floor, wall or ceiling heating
• Cooling by means of convectors, floor, wall or ceiling cooling
• Production of domestic hot water, provided a hot water heater is installed
  

• High efficiency plate heat exchanger
• Energy-efficient circulation pump
• User friendly Colour touch screen controller

• Integrated outside temperature sensor

• DTU module

(The DTU module uses the 4G network to operate your device via the smartphone WarmLink application)

• R290

• Monobloc system
• 1 device for heating, cooling and domestic hot water
• Heating assured at outside temperatures down to -25°C
• Water temperature up to 75°C at outside temperatures down to -7°C
• A+++ at 35°C water temperature
• Standard equipped with a DTU module
• Standard equipped with a Modbus interface
• Easy installation

• Automatic gas separator R290, type PGS
• Anti-vibration mounting blocs, type MPRH
• Room Thermostat, type TS-CLOUD, TS-CLOUD RF (only suitable for heating)
• Buffer tank, type BTE 60, BTE 100
• 3-way zone valve, type TWV

• Deaerator, type AAS

• Magnetic dirt separator, type ADS

• Differential pressure regulator, type DPC

• Filling set, type WFS

• Expansion vessel for heating, type HEV

• Expansion vessel console, type EVC

• Protector, type PAB

• Y-strainer, type YDS

• Start-up is strongly recommended, type XSTARTUPJ

• Domestic hot water heater 200 liters, type SANI-EM 200
• Domestic hot water heater 300 liters, type SANI-EM 300, SANI 300+
• Domestic hot water heater 500 liters, type SANI-EM 500, SANI 500+

Three-way valve not included and has to be provided by the installer.