CGW-M SG • Air/water heat pumps R32 Monobloc

Air/water DC inverter-controlled monoblock heat pump with R32 refrigerant.

All hydraulic components such as a water pump, expansion vessel, pressure relief valve, back-up heater, etc., as well as the heat pump are combined in this monoblock. Thanks to the advanced heat pump technology, the energy from the outside air is absorbed and transferred to the water for home heating and cooling and domestic hot water. The intelligent regulation of the compressor and the expansion valve ensures precise and fast water temperature control, thus reducing energy consumption.

• R-AQUA

• Heating of new or existing houses
• Heating by means of radiators, convectors or floor, wall or ceiling heating
• Cooling by means of convectors, floor, wall or ceiling cooling

• Production of domestic hot water, provided a hot water heater is installed
  

• High efficiency plate heat exchanger
• Energy-efficient circulation pump

• Colour touch screen controller (wired)

• Expansion vessel (2 or 3 liters)
• Safety valve (3 bar)
• Electrical backup heater
• Water pressure sensor

• Integrated outside temperature sensor

• DC inverter-controlled two-stage compressor with gas injection
• DC fan motor
• Gold Fin condenser

• R32

• Monobloc system
• 1 device for heating, cooling and domestic hot water
• Heating assured at outside temperatures down to -25°C
• Water temperature up to 55°C at outside temperatures down to -15°C
• A+++ at 35°C water temperature
• Bivalent setup

• The heat pump will send a signal to an external heat source (eg gas boiler) depending on the outside temperature. This causes the heat pump stoped, and the second source present will provide the heating.

• Smart Grid ready
• Visual indication of energy consumption
• Standard equipped with WiFi
• Standard equipped with Modbus interface
• Easy installation
• EUROVENT EN 14511 and EN 14825 certification
• Keymark certification

• Room Thermostat, type TS-CLOUD, TS-CLOUD RF (only suitable for heating)
• Cascade module, type CASCADE
• Buffer tank, type BTE 60, BTE 100
• Anti-vibration mounting blocks, type MPRH
• 3-way zone valve, type TWV
• Antifreeze valve, type AFP
  

• Deaerator, type AAS

• Magnetic dirt separator, type ADS

• Differential pressure regulator, type DPC

• Filling set, type WFS

• Expansion vessel for heating, type HEV

• Expansion vessel console, type EVC

• Protector, type PAB

• Coding plug for permanently disabling the cooling function, type COD-M-H

• Start-up is strongly recommended, type XSTARTUPJ

Water filter, safety group, anti-freeze protection and expansion vessel MUST be provided on site.

• Domestic hot water heater 200 liters, type SANI-EM 200
• Domestic hot water heater 300 liters, type SANI-EM 300, SANI+ 300
• Domestic hot water heater 500 liters, type SANI-EM 500, SANI+ 500