CVA - MPI • Electrical heating batteries

Circular electrical heating battery with built-in pulser for proportional control, the setpoint of the temperature is set by means of a potentiometer on the battery, maximal outlet temperature of 50°C. The minimal air velocity of 1,5 m/s trough the battery is required. Available in diameter 100 up to 400 mm and in power range from 300 up to 9000 W. Operating voltage 230 or 400 V AC. To measure the desired temperature it is required to connect the supplied sensor.

• Pre-heater
• Zone heater
• Constant supply air temperatuur

• Casing made of aluzinc coated steel, with rubber rings on either side for air tightness
• Heating elements made of stainless steel ASI 304

• Two-stage overheat protection: the first stage switches on when the temperature reaches 50°C (resets automatically), the second stage switches on when the temperature reaches 100°C (is reset manually with pushbutton on the casing).
• Setpoint temperature range : 0° to 30°C.

• Circulair ducts

• The heating batteries shall be electrical, of the circular type, made of steel. The heating elements shall be made of stainless steel AISI 304. They shall be equipped with a two-stage overheat protection with automatic reset and manual reset button. Rubber rings shall be fixed on either side for air tightness when mounted to the duct.

CVA, 200, 1f, 2400, -MPI

Explanation

CVA - MPI = Electrical heater with built-in control and setpoint

200 = Diameter in mm, (see table)

1f = Supply voltage single phase 230V, 2f = Single phase 400V, 3f = 3 phase 400V

2400 = Heating power in W, (see table)