KDM • Control valves

Circular control valves with manual quadrant.

Channeling system with EPDM sealing, airthightness until class EN12237, depending on the assembly.

Enclosure airthight to EN 1751 class C. The airthightness class is also determined by the mounting on the construction site.

• Controle valve type KDM can be motorized with a actuator type LM, NM, LF or NF/SF
• If used with servomotor type LM, a mounting plate type MP-LM is obligatory. An axe extension type AEX-12/M6 100 mm is necessary for KDM 80 until KDM 400
• If used with servomotor type NM, a mounting plate type MP-NM is obligatory. An axe extension type AEX-12/M6 100 mm is necessary for KDM 80 until KDM 400
• If used with servomotor type LF, a mounting plate type MP-LF is obligatory. An axe extension type AEX-12/M6 100 mm is necessary for KDM 80 until KDM 400
• If used with servomotor type NF or SF, a mounting plate type MP-NF/SF is obligatory. An axe extension type AEX-12/M6 100 mm is necessary for KDM 80 until KDM 400
• An actuator with more than 5Nm (NM, NF or SF) is recommended for KDM size 560 and 630
• From KDM diameter 450 the valve is already equipped with an axle extension so no extension will be needed.

• Air tight control valves, type AKH

• A circular control valve with manual quadrant is used for a good regulation of the air flow. If necessary the valve can be motorized by replacing the manual quadrant into a servomotor type Belimo LM. In that case a mounting plate (type MP-LM) and axe extension (type AEX-12/M6 100 mm) are recommanded.
• type KDM

• KDM, 250

Explanation :

KDM = Type of valve

250 = Diameter of valve