The HRC70 40 is an air/water heat pump that is suitable for heating water at high temperatures. The monoblock unit is filled with the natural refrigerant propane (R290) and easily reaches water temperatures of up to 70°C. The device guarantees proper operation at outside temperatures down to -20°C.
The HRC70 40 is heating only unit that uses 2 scroll compressors of equal capacity, which are equipped with soft starters as standard. This ensures 2 power stages and low power consumption. Due to the specific construction, the device will switch to defrost mode less often and the defrost cycle will be completed as efficiently as possible.
The unit maintains its high COP values even at negative outside temperatures. Possibility to cascade 3 HRC70 40 devices for a total power of 120 kW.
Monoblock heat pump (outdoor) HRC70 40 kW with :
- 10 m long bus cable for communication between the HRC70 40 and the Pilote Z1 (3 core and already connected to HRC70 40) (do not place in parallel with power
cable).
- Flexible pipes (Durite) of 5 m long and rigid insulated pipe to
indoor module (diameter according to distance between the two, see table at the
bottom of this page).
- Filter 1"1/4 already installed in the return duct of the heat pump.
- Primary pump already installed in the heat pump.
- 2,5 bar pressure relief valve mounted in the heat pump.
Indoor module Pilote Z1:
- 1x secondary pump
- Buffertank/hydraulic decoupling bottle 78L with air vent and release valve
- Pressure sensor
- Flow meter
- Electronic regulation
- USB stick (comes with manual)
- Shut-off valve 1 "1/4
- Filter tap 1 "1/4
- Outdoor sensor for weather dependent control